X- Link
$79.99

Wired Remote extender work VCR, SATELLITE, LD or any IR device from a remote location ! Standard Coax IR Repeating. Hardwired Solution. IR is wired back to the device. Uses Coax Cable that already run to the remote location or use 2 conductor / Telephone line.

X-LinkOther room Kit
$59.99

extra room kit - Wired Remote extender work VCR, SATELLITE, LD or any IR device from a remote location ! Standard Coax IR Repeating. Hardwired Solution. IR is wired back to the device. Uses Coax Cable that already run to the remote location or use 2 conductor / Telephone line

IR Injector
$35.99

INJ94 RF/IR Injector

·Injects or controls IR signals

·'F' coaxial connector jacks for TV and input signals

·3.5mm IR receiver stereo mini jack for quick connection of IR receivers

·2.1mm +12V jack for connection

IR Coupler
$29.99

CPL94B RF/ IR Coupler

·Extracts IR control signals

·'F' coaxial connector jacks for SAT/VCR and remote TV signals

·Two 3.5mm emitter mono mini jacks with 470 Ohm series resistors

IRT5 Room Target
$39.99

Standard IR Repeating Works with All in One distribution systems, model 2100Aand 2010 wallplates. Also works with COAX injectors

Mini T5 Room Target
$119.99

Miniature infrared receiver
7-ft ribbon cable works with mini 3-conductor or Coax cable RG-6
Extremely small package: .437' x .312' x 2.125'
Talkback red LED tests system for correct wiring as well as indicating infrared reception
Infrared modulation frequency bandwidth: 30–100 kHz
Nominal reception range: > 30 ft
Nominal reception angle: 55° off-axis
Requires Power Supply
Black

IRE1 Emitter
$9.99

Works with All in One distribution systems, model 2100A and 2010 wallplates.

IR-Block 2 conductor IR Coupler

·Extracts IR control signals form 2 conductor

·'Phone line 2 conductor connector jacks for SAT/VCR or other IR device.

12V Power Supply
$19.99

• 12-volt AC to DC adapter
• Provides low-voltage power to common IR products.

Most electronic components come with 12-volt AC to DC adapters, but if you lose or accidentally damage this device, you can replace it with the 12-Volt Regulated Power Supply, an all-purpose adapter that fits nearly any common household product requiring low-voltage DC power.

If you are using coax lines to carry IR and other DC signals, use this DC IR Signal Block on output lines that connect directly. The DC Block will prevent the DC signal from being shorted.

If your looking to put together a whole house IR distribution system please call. We have several solutions and carry a full line of IR products. Some IR repeaters just can't handle tons of IR such as a IR Mouse, Drapes, Projection Screens and AC units. Flooded IR Control. Please Call.

Connecting IR Block
$14.99

Connecting Block Provides Link Between IR Remote and A/V Components

IR-Block 2 conductorIR Inserter

·Inserts IR control signals form 2 conductor

·'Phone line 2 conductor connector jacks for SAT/VCR or other IR device.

C-1201 IR Distribution Module

·8 IR receivers into one common output

·Combines multiple rooms to one connecting block

·3 wire input

·Optional power input port to compensate for long wire runs

IR-Block 2 conductor IR Coupler

·Extracts IR control signals form 2 conductor

·'Phone line 2 conductor connector jacks for SAT/VCR or other IR device.

CALL

R-Block 2 conductor IR Coupler

·Extracts IR control signals form 2 conductor

·'Phone line 2 conductor connector jacks for SAT/VCR or other IR device.

D930 RCA CONES
$49.99

Allows user to control DSS receiver or any IR device from 2nd room. Converts IR signal to radiofrequency and back to IR

D935 RCA CONE
$34.99

Allows user to control DSS receiver or any IR device from 3rd room. Converts IR signal to radiofrequency and back to IR. (D930 RCA CONES Needed)

X-10 Powermids 1 set
$45.98

Allows user to control DSS receiver or any IR device from 2nd room. Converts IR signal to radiofrequency and back to IR. (Complete Set 2 powermids)

X-10PMD2 2nd Transmitter
$36.98

Allows user to control DSS receiver or any IR device from 3rd room. Converts IR signal to radio frequency and back to IR. ( X-10 Powermids Needed) 1/2 set 1 powermid for another remote location.

TUBE STYLE REGULATED EASY CONNECT INFRARED REPEATER

Cabinet and Enclosure IR. Exceptional Range & Performance Talk-back LED Amplified input for long wire runs Range up to 40 feet, acceptance angel 130 degrees Extensive shielding eliminates interference Install by drilling a 1/2 inch hole.

Infrared eyeballs

5020 less expensive Power supply for IR

·UL and CSA approved

·12 VDC, 500 mA regulated

Peephole IR Receiver
$99.99

• Control audio/video equipment from 40 feet away
• Unobtrusive design allows for stealth installations
• Installation and trim hardware included

Miniature infrared receiver

EZIR - IR Receiver
$79.99

• Use your existing remotes to operate your A/V system from anywhere in the house
• Enjoy the ultimate in flexibility when controlling home entertainment through cabinet / Door / Housing / Distribution /

Miniature infrared receiver

Rack Mount IR Products

Also see Connectors & Y-cables

Y-ing the mini-jacks for multiple Flashers and mini-jack cable extensions the adapter jack connects 3.5mm mono cables

Remember you must use IR approved, all port power passive splitters, when doing IR repeater/distribution systems. We have 2, 4, 6, 8, 12 and 16-way splitter/combiners all pass IR (infrared).

Please call and we will help you put together, 'The ultimate infrared Solution.'

2010
$ Call

See Modulators

Remote power wallplate for coax panels Works with models 3308 or 8200.Put the coax panel where the coax cables are (garage, basement, attic) and power the panel from the media center.Drives standard IR emitters. Works with standard and bi-directional IR.

Wall mount / wall plate IR Receiver available

2100A
$ Call

See Modulators

Wallplate for bi-directional IR & IR target for bi-directional IRInterfaces industry standard IR targets to bi-directional IR coax panels. Works with model 3108A, 3212A & 3308 coax panels. Any 2100A can have a target and/or an emitter. One 2100A per TV drop required.

IR wall Target and Pinhole IR receivers

IRE2 Emitter

$12.99

• Emitters stick directly onto the AV equipment
• Universal compatibility with dozens of brands of IR controllers
• For use with Connecting Blocks and Home Automation controllers

IRE2L Light Up IR Emitter

$14.99

• Light Up IR Flasher Emitter ( nice )
• Emitters stick directly onto the AV equipment
• Universal compatibility with dozens of brands of IR controllers
• For use with Connecting Blocks and Home Automation controllers

Cabinet and enclosure IR. Sending infrared inside. Relatively simple, and we have 4 different types. Please call.

Don't forget about these ! Complete windows IR keyboard with trackball mouse. Totally IR (infrared). This is the ultimate to finish any IR repeater system. PC in the closet baby !! Order 5 for a whole house solution. Adjustable IR for multiple PC's in the same room or over the same system. Awesome !

IRT5 Room Target
$39.99

Standard IR Repeating Works with All in One distribution systems, model 2100Aand 2010 wallplates. Also works with COAX injectors

Miniature infrared receiver

IR for Integrated Modulators
$ Call
The All in One and All in Two systems use model 2133 targets (5 volt system) and any of our emitters. The model 2100A wallplate and the 12volt targets are not compatible. ( See Modulators )

Infrared Remote Extender
$59.99

• Extends the range of any remote control and operates through obstacles from up to 120 feet away
  
• Freestanding units works with most remote controls and A/V components
  
• Installs Easily
  
• Expandable system:

Infrared Remote Extender
$79.99

Use a remote through walls from anywhere* in your home! Attaches to most IR remotes Converts IR to radio frequency Extend remote range up to 150 ft.*